RESIDENTIAL DIGITAL CONTROLLER RDC2/DC2

Markets: Residential
Models 8/10/12RESV, 8/10/12RESVL, 14/20RESA, 14/20RESAL, 20RESB, 20RESC/L, 20RESD and 24-60RCL/38RCLB

The RDC2/DC2 firmware (application program) is factory loaded and used for field upgrades or replacements.

SiteTech or OnCue or USB Utility software is required to upgrade the controller firmware.

Notice: Do not load an earlier version over a later version of the firmware.

Version 6.12.2 Release date 11/15/2016
Update: Various Corrections.

Version 6.11.2 Release date 2/18/2016
Update:
- Added support for new models.
- Fixes the S/N mismatch between the controller UI and SiteTech.
- Power Ratings updated for models 24RCL, 60RCL and 48RCL.
- Removed Voltage selections of 200V, 220V, 230V for 50Hz, Single Phase connections.

Version 6.09.0 Release date 9/28/2015
Update:
- Improved RDC2 performance with OnCue Plus on high latency networks.
- Fixed controller lock up issue with OnCue Plus connectivity.
- Fixed a reset issue when the controller is in Non-English language mode.

Version 6.07.0 Release date 3/19/2015
Update:
- MPO Voltage Regulator fix for all models
- Update enhanced diagnostics for 2.2 L
- Improvements for Ethernet Reset and connectivity issues.
- Engine Temperature fix on the Controller UI
- Maintenance hours fix on the Controller UI

Version 6.05.0 Release date 11/21/2014
Update: Addresses the voltage overshoot and has the fix for loss of parameter settings on firmware upgrade.

Version 6.03.0 Release date 10/21/2014
Update: Main Power Overload correction for 14RESA model.

Version 6.02.0 Release date 10/2/2014
Update:
- Resolve Main Power Overload Issue
- Increase delay for low battery voltage to avoid race condition with MPO
- Fix issue with green board controllers generating low voltage rather than MPO
- Update kW rating limits for 12RESV and 14/20RESA(L)

Version 5.10
Update: Added support for model 60RCL.

Version 5.07
Update: OnCue Plus: Remote monitoring support for OnCue Plus. OnCue will only work with USB.

Version 5.06
Update: E-stop support, enhanced excitation control and additional model support.

Version 5.04
Update: Advanced speed control, advanced diagnostic exercise, DC2 biweekly exercise, load control with remote ATS.

Version 5.02
Update: Fixed ATS exercise.

Version 4.09
Update: Fixed blank controller screen after intializing.

Version 4.07
Update: Corrections.

Version 4.03
Original Release